DS2107A |
RFQ for DS2107A Required Field |
 |
| Product | Manufacturers | Pack | D/C |
| DS2107A | Maxim | - | 2001 |
The SCSI-2 standard recommends the use of active terminations at both ends of every cable segment in a SCSI system with single-ended drivers and receivers. The DS2107A SCSI Terminator, which is fully compliant with the standard, enables the designer to gain the benefits of active termination: greater immunity to voltage drops on the TERMPWR (TERMination PoWeR) line, enhanced high-level noise immunity, intrinsic TERMPWR decoupling, and very low quiescent current consumption. The DS2107A integrates a regulator and nine precise switched 110 ohm termination resistors into a monolithic IC.
Features |
| • Fully compliant with SCSI and SCSI-2 standards• Backward compatible to the DS2107S• Provides active termination for 9 signal lines• Laser-trimmed 110 ohm termination resistors have 1% tolerance• Low dropout voltage• Power-down mode isolates termination resistors from the bus• Handles actively negated SCSI signals• Onboard thermal shutdown circuitry• 16-pin plastic SOIC (DS2107AS) and 20-pin plastic thin SSOP (DS2107AE) |
| Models | MFG | Pack |
| DS2064-200 | ||
| DS2064S | ||
| DS2107CS | ||
| DS2107S | ||
| DS2107S/AS/AE | ||
| DS2108 | Maxim | SOP24 |
| DS2108S | ||
| DS2108S/TR | ||
| DS2109 | Maxim | SOP24 |
| DS2109S | ||
| DS2109S/TR | ||
| DS2109S-TR | ||
| DS2110 | ||
| DS21107E | ||
| DS2110AA | ||
| DS2110S | ||
| DS2112 | ||
| DS2112A | ||
| DS2114Z | ||
| DS21154-AB | ||
| DS2117 | ||
| DS21177 | ||
| DS2117M | Maxim | |
| DS2117MB | ||
| DS2117MBTR | ||
| DS2118 | ||
| DS2118BM | ||
| DS2118M | Maxim | |
| DS2001 | ||
| DS2001CJ DS9665CJ | ||
| DS2106SY | ||
| DS2106S/T&R | ||
| DS2106 | ||
| DS2105 | ||
| DS2103SY | ||
| DS2102SY | ||
| DS2102SV | ||
| DS2101SY | ||
| DS2101SV | ||
| DS2-08A | ||
| DS2070W | ||
| DS2064 | ||
| DS205 | ||
| DS2045Y | ||
| DS2045W | ||
| DS2045L | ||
| DS2045AB | ||
| DS2030Y | ||
| DS2030AB | ||
| DS2016 |
